Oki Pos 441 - Manual (Page 42)

– –
10. Dip Switch Setting
A DIP switch is provided at the bottom of the printer, and can be set as given in the table be-
low. Be sure to set the power switch to off before changing the settings. It is recommended to
use a pointed item like a pen or flat-blade driver screw to change the settings. The settings will
become effective when the power switch is set to on again.
The following is the procedure for changing the settings on DIP switches.
. Make sure the printer is turned off.
. Remove the screw from the DIP switch cover. Then take off the DIP switch cover, as shown
in the illustration below.
. Set the switches using a pointed tool, such as a pen or flat-blade screwdriver.
4. Replace the DIP switch cover. Then secure it with the screw.
The new settings take effect when you turn on the printer.
8
1
Power OFF
OFF ON