Omega Speaker Systems OMEGAFLEX FPU5-MT-220 - Manual (Page 4)

Page
Unpacking Instructions ............................................................................ i
Chapter 1 Introduction ....................................................................... 1-1
1.1 Description .................................................................................... 1-1
1.2 Features .......................................................................................... 1-1
Chapter 2 Parts of the Pump Motor ................................................... 2-1
2.1 Front View ..................................................................................... 2-1
2.2 Left Side View ............................................................................... 2-2
2.3 Right Side View ............................................................................. 2-3
2.4 Membrane Keypad and Display ................................................ 2-4
2.5 Rear View........................................................................................ 2-6
Chapter 3 Getting Started .................................................................. 3-1
3.1 Attaching the Pump ..................................................................... 3-1
3.1.1 Introduction ................................................................................... 3-1
3.1.2 Attaching a Single Pump Directly to the Motor ....................... 3-2
3.1.3 Stacking Two Pumps on One Side of the Motor ...................... 3-3
3.2 Selecting Tubing ............................................................................ 3-4
3.3 Tubing Life ..................................................................................... 3-4
3.4 Loading the Tubing ...................................................................... 3-4
Chapter 4 Turning on the Power ........................................................ 4-1
4.1 Introduction to the Two Display Modes ................................... 4-1
4.2 Using the ON/OFF Switch .......................................................... 4-1
4.3 The STOPPED Display Mode ..................................................... 4-1
4.4 The RUNNING Display Mode ................................................... 4-2
Chapter 5 Operating the Pump Motor in the STOPPED Display Mode .. 5-1
5.1 Displaying Pump Messages in Five Different Languages ...... 5-1
5.2 Defining the Direction of Pumping ............................................ 5-3
5.3 Selecting the Tubing Inner Diameter ......................................... 5-4
5.4 Priming the Tubing ....................................................................... 5-6
5.5 Calibrating the Tubing ................................................................. 5-6
5.6 Measuring the Temperature of a Fluid ...................................... 5-9
5.7 Preparing for Pumping in a Specific Mode ............................... 5-9
Chapter 6 Operating the Pump Motor in the RUNNING Display Mode . 6-1
6.1 The RPM Mode ............................................................................. 6-1
6.1.1 Pumping in the RPM Mode ........................................................ 6-1
6.2 The FLOW RATE Mode ............................................................... 6-5
6.2.1 Pumping in the FLOW RATE Mode .......................................... 6-5
6.3 The TIME Mode .......................................................................... 6-11
6.3.1 Pumping in the TIME Mode ..................................................... 6-11
6.4 The TOTAL VOLUME Mode .................................................... 6-16
6.4.1 Pumping in the Total Volume Mode ........................................ 6-17
6.5 Preventing Tubing from Moving During Pump Operation . 6-21
Peristaltic Pump Motor
ii
TABLE OF
CONTENTS