Omega Speaker Systems OMEGAFLEX FPU5-MT-220 - Manual (Page 38)

Operating the Pump Motor in the
RUNNING Display Mode
6-1
6
6.1 The RPM Mode
Figure 6-1 shows the overall block diagram of the RPM Mode in the RUNNING
Display Mode
.
Figure 6-1. Block Diagram: Pumping in the RPM Mode
In the RPM Mode, you pump fluid at a certain motor speed, without setting the
amount of time you pump or the volume you dispense. The pump motor
measures the time of pumping and volume of fluid dispensed but ignores the
TIME and TOTAL VOLUME settings.
6.1.1 Pumping in the RPM Mode
To pump fluid in the RPM Mode, do the following:
1. Set up the pump motor for pumping, according to Chapter 3.
2. Toggle the ON/OFF switch to turn on the unit’s power. The display is in the
STOPPED Display Mode
. Refer to Figure 6-1.
3. Either set the tube ID for the tube you are using (following Section 5.3) or
calibrate the tubing (following Section 5.5) before continuing.
4. Press the RPM key. The display flashes the current RPM setting (xxx rpm).
xxx rpm
RPM
ACTION
Displays current
RPM setting
Display shows
START
STOP START
STOP
OR
(Optional)
CALIBRATE
STOPPED
DISPLAY
MODE
CURRENT
RPM
SETTING
RPM
RPM SETTING
TO BE USED IN
PUMPING
ACTUAL
RPM
VALUE
(Refer to Section 5.5)
RUNNING
DISPLAY
MODE
OR
TUBE ID SETTING
TO BE USED IN
PUMPING
CURRENT
TUBE ID
SETTING
TUBE ID