Onkyo FR-N3X - Manual (Page 25)

25
◆
Switching the display information
Pressing DISPLAY on the main unit repeatedly toggles between two types of information display.
◆
Using the remote controller
◆
Manually tuning a broadcast station
You can also tune in radio stations manually.
1 Turn on the power to the FR-N3X.
2 Select FM or AM.
3 Press TUNING or repeatedly while observ-
ing the display to tune in the desired frequency.
Each press of the button changes the frequency by
50kHz for FM and 9kHz for AM. Pressing and hold-
ing down the button for more than one second will
change the frequency continuously. While FM is
selected, pressing and holding
or down a
while, then releasing it, will automatically raise (or
lower) the frequency.
If FM reception is not good
When an FM stereo broadcast is being received, “ST”
lights up on the display. However, if the signal is weak
or too much noise interferes, it will not light up. In this
case, press MODE to switch to monaural reception.
(“AUTO” turns off.) This could reduce noise and inter-
mittent cut-outs.
To return to AUTO tuning, press MODE again.
FM/AM frequency
Preset channel name (*)
* If a given preset channel is not named, the unit displays
“No Name,” then indicates the frequency. See “Naming
an MD, and its tracks, and preset channels” on page 52.
Selects an FM/AM station.
Adjust the volume level.
(Pressing VOLUME
increases the volume
level, and pressing
VOLUME decreases
the level.)
Selects a preset channel.
(Pressing selects a lower
channel number and pressing
selects a higher channel
number.)
Enables you to manually tune
in a broadcast station.
(See below.)
Press the number buttons as
described in the examples
below to select the desired
preset channel
Preset
channel
represents the tens digit.
8
10
22
, ,
Press
8
10/0
2 2 --/---
--/---