Oricom DECT ECO7100-1 - Manual (Page 33)

31
ANSWERING SYSTEM CORdEd BASE OpERATIONS
Corded Base Operations
Set Date and Time
Press and hold OK/CLK button, the LCD will be
displayed:
- - : - - AM - - D/ - - M
Select AM/PM Key in the time and date, you can
erase the entered content by pressing Mute/C/Delete
button if you made an error.
Press OK/CLK button to save the setting. A
confirmation beep will be emitted.
Make a call
Pre-dialling - Dial the number in standby mode and
then pick up the corded handset or press Speaker
button to make the call directly
Note:
You can press BACK button to erase the digits
if you made an error.
Direct dialling - Pick up the corded handset or press
Speaker button, then dial the number you want to
call
Note:
You won’t be able to erase and correct the
entered digits in direct dialling mode.
Volume control
During the call, you can adjust the handset receiver/
base speaker volume by pressing Volume up/down
button.
There are 5 ringer volume levels available: L1, L2,
L3, L4, L5 .
In standby mode, you can adjust the base ringer
volume by pressing Volume up/ down button.
There are 6 ringer volume levels available: L0, L1,
L2, L3, L4, L5 .
You can also turn off the base ringer by simply
pressing and holding the # button in standby mode,
the ring off icon will be displayed on the LCD.
Press and hold # button again to turn on the base
ringer, the ringer level will be same as previous
setting.
Mute Function
During the call, press the Mute/C/Delete button to
activate/ deactivate mute function
Note:
The Mute icon will be displayed on the LCD
when mute is activated, and the caller won't be
able to hear you.