Oricom DECT ECO7100-1 - Manual (Page 17)

15
Cordless Handset Operations
Switching ON/ OFF
Press and hold the END button for more than 2
seconds to switch on/off the handset in standby mode.
You can switch the handset off to save battery charge.
Note:
The handset cannot be used for Emergency
calls when switched off. Also, it won’t ring during
an incoming call. You need to switch it back on
to answer a call, which might take some time for
the handset to re-establish a radio link with the
base unit.
Make a call
You can input with maximum 24 digits.
Pre-dialing
- Dial the number and then press TALK
button.
Note:
You can press BACK button to erase the digits
if you made an error.
Direct dialing - Press TALK button first and then dial
the number
Note:
You won’t be able to erase and correct the entered
digits in direct dialing mode.
You can also call from Call log/Redial
list/Phonebook
Call from call log
Press Navigation Up button in standby mode and
select the desired entry by using Up/down button
Press TALK button to make a call
Note:
You need subscribe to Caller Line identification
service to view the caller’s number or name in
the call log.
Call from Redial list
Press Redial button in standby mode and select the
desired entry by using up/down button
Press TALK button to make a call
Call from Phonebook
Press Phonebook button in standby mode and select
the desired entry by using up/down button
Press TALK button to make a call
Answer and End a call
Answer – Press TALK button to answer a call when
the phone rings
End
– Press END button to end a conversation
COREdE BASE LCd LAYOUT CORdLESS HANdSET OpERATIONS