Onkyo HT-R490 - Manual (Page 8)

8
Front panel facilities
0
Input Selector Buttons (DVD, VIDEO 1, VIDEO 2,
FM, AM, TAPE and CD)
These buttons are used to select the input source. Pressing and
holding the TAPE button for about 2 seconds allows the TAPE and
MD sources to be switched.
-
BASS and TREBLE control knobs
Boosts or cuts the bass and treble response.
BASS: Adjusts the bass response from the Front speakers. Turn
the knob clockwise to boost the bass response. Turn the knob
counterclockwise to cut the bass response.
TREBLE: Adjusts the treble response from the Front speakers.
Turn the knob clockwise to boost the treble response. Turn the
knob counterclockwise to cut the treble response.
=
Remote control sensor
This sensor receives the control signals from the remote controller.
~
SP SEL button
Press to select the optimum speaker configuration.
!
SW MODE button
Press to select the subwoofer mode.
@
DIGITAL INPUT button
When digital components are connected to the DIGITAL INPUT
jacks of the HT-R490, use this button to assign the DIGITAL
INPUT jacks to them according to their forms of connection.
#
FM MODE button
Press to switch the reception mode between stereo and monaural.
If audio is interrupted or noise interferes with audio during FM
stereo broadcasting, press this button to switch to the monaural
reception mode.
$
MEMORY button
This button is used to assign the radio station that is currently
tuned in to a preset channel or delete a previously preset station.
%
TUNING
™/£ buttons
Use these buttons to change the tuner frequency. The tuner
frequency is displayed in the front display and it can be changed in
50 kHz increments for FM and 10 kHz increments for AM.
When FM is selected, you can hold down one of the TUNING ™/£
buttons and then release it to activate the auto-search feature. It will
search for a station in the direction of the button you pressed and stop
when it tunes into one.
^
PRESET
™/£ buttons
These buttons make it possible to store desired radio stations under
the desired preset numbers and recall them with an easy operation.
&
Display
A
SPEAKERS A/B indicators
Shows the current speaker system in use.
B
SLEEP indicator
Lights up when the sleep timer is active.
C
Source/Listening mode indicators
One of these indicators lights to show the format of the current
source as “PCM DIGITAL”, “
Ÿ DIGITAL” or “DTS”. In
addition, one of the listening mode indicators “
Ÿ PRO
LOGIC II”, “DSP” and “STEREO” lights according to the
current listening mode.
D
MUTING indicator
Flashes when the mute function is active.
E
FM STEREO indicator
Lights up when an FM stereo broadcast station is received.
F
TUNED indicator
Lights up when a radio station is received.
G
MEMORY indicator
Lights up when the MEMORY button is pressed in the radio
station preset operation.
H
FM MUTE indicator
Lights up to indicate FM muting. It extinguishes when the
monaural reception mode is started by pressing the FM MODE
button.
I
Multi function display
In usual operation, shows the current input source and volume.
When the FM or AM input is selected, it shows the frequency
and preset number. When the DISPLAY button is pressed, it
shows the listening mode and input source format. However, it
does not show the source format when the FM or AM source is
selected.