beautypg.com

Speaker setup, Selecting the speaker configuration, Setting the subwoofer mode – Onkyo HT-R490 User Manual

Page 21: Press the test tone button, Press the test tone button to complete adjustment

background image

21

Speaker Setup

You need to set up the speaker configuration for the speaker
system connected to the SPEAKERS A terminals (see page 17).

Notes:

• The speakers cannot be set up for optimum audio reproduction

if the SPEAKERS B system is On (see page 7).

• It is not necessary to set up again once you have completed the

setup unless you change the speaker configuration.

Selecting the speaker configuration

Press SP SEL button repeatedly to select the number of
channels for the SPEAKERS A system.

When the button is pressed, the current speaker setup will be
displayed for about 5 seconds. If you want to change it, press the
same button again within the 5 seconds.

When the button is pressed repeatedly, the number of channels
changes as follows:

Setting the subwoofer mode

Press SW MODE button repeatedly to select the
subwoofer mode.

When the button is pressed, the current subwoofer mode will be
displayed for about 5 seconds. If you want to change it, press the
same button again within the 5 seconds.

When the button is pressed repeatedly, the subwoofer mode
changes as follows:

Note:

When the subwoofer mode is set to MODE 2 and audio is
reproduced in the STEREO mode, the subwoofer may not output
audio from certain sources (2 channel-Dolby Digital/DTS source
etc.).

Adjusting each speaker’s relative volume
balance (Remote controller only)

Adjust each speaker’s relative volume balance so that the volume
of all speaker’s test tones sound equal at the listening position.

1. Press the TEST TONE button.

Adjust the volume by gently increasing it with the VOLUME
5 button. Each speaker produces the test tone (pink noise) in
the following order:

2. To adjust the level of each speaker, press the

CH SEL button to select a speaker and press the
LEVEL

5/ buttons to raise or lower the level.

The test tone should sound at the same level when you hear it
in your listening position. You can adjust the level in the range
between –12 dB to +12 dB.

3. Press the TEST TONE button to complete

adjustment.

Front left and right speakers

Front left, right, and center speakers

Front left and right, plus surround
left and right speakers

Front left, right, and center, plus
surround left and right speakers

When small-with limited bass signal
handling-front speakers are connected

When large-wideband-front speakers
are connected

When no subwoofer is connected

Front left speaker

Center speaker

Front right speaker

Surround right speaker

Surround left speaker

Subwoofer

MODE

RC-446M

REMOTE CONTROLLER

STANDBY/ON

OFF

ON

POWER

MASTER VOLUME

BASS

TREBLE

AV RECEIVER

HT-R490

FM

AM

C D

TAPE

VIDEO

1

DVD

A

B

SPEAKERS

DIMMER

SURROUND

DTS

/

VIDEO

2

VCR

AUDIO

SELECTOR

LISTENING MODE

DSP

STEREO

DISPLAY

STANDBY

SP SEL

TUNING

PRESET

MEMORY

SW MODE

DIGITAL INPUT

FM MODE

CLEAR

INPUT SELECTOR

SLEEP

DIMMER DISPLAY

CD

TAPE

TUNER

D V D

VIDEO 1 VIDEO 2

SUR MODE SW MODE AUDIO SEL

TUNER

PRESE T

STANDBY/ ON

DISC

MUTING

VOLUME

TOP MENU

MENU

CH SEL

RETURN

SETUP

TEST TONE

LEVEL

E N T E R

SP SEL

TEST TONE

CH SEL

SW MODE

LEVEL

5/

SW MODE

VOLUME

5/

CH

TV/ VCR

CH

T V VOL

T V VOL

TV

CABLE SATELLITE

VCR

STANDBY/ ON

DVD

CD

TAPE