Omega WI8XX-U - Manual (Page 43)

4.3.6 Controller Setup (continued)
Below are the definitions of terms used in the Controller Setup page.
A) Setup:
Clicking on the options shown, allows user to modify the different parameters
shown under this menu (see Section 4.3.7. Setup Page for more details).
B) Monitor:
Scrolling: If checked, the Meter will display data from all the End Devices.
Otherwise, it only displays data from the End Device specified on Device ID.
End Device ID: Address/ID of the End Device that will be display on the Meter.
C) Transmission Power:
PID (Network ID): The Personal Network ID (0 to 65535). In parenthesis is the
firmware version of the radio module. The firmware version is also shown on a
label attached to the Meter (see Figure 3.1).
The Meter always has an address of 0.
Channel: Choose the operation channel defined in IEEE 802.15.4 for the
sensor network.
Transmission Power: This determines the signal power transmitted by the
Meter. The options are 10 dBm and 20 dBm.
Please refer to local regulations for the allowed maximum transmission
power.
For additional details, please refer to Appendix F.
D) Miscellaneous:
iSeries Version: The firmware version of the Meter. The firmware version is
also shown on a label attached to the Meter (see Figure 3.1).
Changes made on the Controller Setup page will take place after clicking
the Reset Controller button or simply power recycling the meter.
37