Opticon NFT 2100 - Manual (Page 20)

Manual No. 25-ULNFT2100-01; Mar, 2005 NFT 2100 CCD Fixed Mount Barcode
Scanner
Page 17
When the scanner is in the Programming Mode, you can change more than one parameter at a time.
However, this may become confusing. Until you become proficient at programming you may prefer to
change only a few parameters at one time. We recommend that you keep a record of the changes you
have made to the scanner. Note, while you are in the programming mode the scanner will not read
regular bar codes.
What if you make a mistake?
Don’t worry. If you are programming the scanner but are unsure of which parameters have been
changed, scan the Reset All Defaults bar code. This bar code returns the scanner to the default
settings that were installed in the factory at the time the product was manufactured. Scanning this bar
code erases any changes you have made, including any changes that were made during previous
programming.
Reset All Defaults U2 Command
This command will return all settings to the defaults that were installed in the factory