Opticon NFT 2100 - Manual (Page 17)

Manual No. 25-ULNFT2100-01; Mar, 2005 NFT 2100 CCD Fixed Mount Barcode
Scanner
Page 14
OPTICON
NFT-2100-I-RS232C
xxxxxx
MADE IN JAPAN
******
Section 6
Scanner Labeling
IEC 825-1 Class 1 LED Devices
The NFT 2100 has been examined and found to be a CE Class 1 LED Device according to the relevant
requirements of IEC 825-1 and corresponding EN 60825-1 (1993-11) including amendment 1 (1997-09)
and amendment 2 (2001-01).
The NFT 2100 scanner uses low-power visible LEDs. As with any very bright light source, such as a
flashlight, you should avoid staring into the light. Momentary exposure to an IEC 825-1 Class 1 LED is
not known to be harmful.
A manufacturer’s label, as shown below, indicating the manufacturer, product model, ordering number,
serial number, CE mark and place of manufacture is affixed to each scanner.
Section 7
Scanner Servicing and Maintenance
The NFT 2100 scanner contains no user adjustable or serviceable parts in the interior of the scanner. All
product service must be performed by the Opticon Service Department in Orangeburg, NY. Opening the
scanner will void the warranty.
The NFT 2100 is warranted for 7 year including parts and workmanship. If you need warranty or out-of-
warranty repair, first call 1-800-636-0090 to obtain a Returned Material Authorization (RMA)
number. You will be provided a number and shipping instructions.
There is no scheduled maintenance required for the NFT 2100. The scanner can be cleaned using a
water dampened, lint free or lens cloth. Be careful to avoid excessive moisture that would penetrate the
housing or obscure the window. While use of cleaning fluids other than water are not recommended, a
neutral detergent or ethanol would be preferred if necessary. Do not use bleach at full or diluted
strength as damage to the painted case and/or window may result.
Ordering Number
Serial Number