Onkyo HT-R520 - Manual (Page 33)

33
Playing Your AV Components —Continued
You can display various information about the current
input source as follows.
The following information can typically be displayed for
input sources.
*If the input signal is analog, no format information is
displayed. If the input signal is PCM, the sampling fre-
quency is displayed. If the input signal is digital but not
PCM, the signal format is displayed. Information is dis-
played for about three seconds, then the previously dis-
played information reappears.
Interpreting Surround Channel Information
A: The number of front channels (front left, front right,
and center).
B: The number of surround channels (surround left and
surround right). If there’s a surround back channel
information, this number will be 3.
C: LFE channel for subwoofer (1 means yes).
The multichannel input is for connecting a component
with individual 5.1-channel analog audio outputs, such
as a DVD player or MPEG decoder.
See “DVD Multichannel Connection” on page 24 for
connection information.
Note that the individual speaker level settings for the
multichannel input are independent of those explained
on page 47.
Notes:
• While the multichannel input is selected, you can
select only the Direct listening mode. If you select the
multichannel input while using another listening
mode, that listening mode is cancelled.
• While the multichannel input is selected, the Speaker
Configuration settings on page 48 are ignored, and
signals from the multichannel input are fed to the front
left, front right, center, surround left, and surround
right speakers and subwoofer regardless of those set-
tings.
Displaying Source Information
Press the [DISPLAY] button
repeatedly to cycle through the
available information.
DISPLAY
Input source
& volume
Signal format*
or sampling
frequency
Input source
& listening
mode
A B C
Using the Multichannel Input
1 Press the [AMP] button followed
by the [MULTI CH] button so that
“MULTI” appears on the display.
Audio from the multichannel input will
now be used for the DVD input source.
2 To adjust the level of individual
speakers, use the remote con-
troller’s [CH SEL] button to select
them, and then use the [LEVEL–]
and [LEVEL+] buttons.
The level can be adjusted from –12 to
+12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
AMP
MULTI CH
CH SEL
LEVEL+ LEVEL-