9 scenario 3: metering, Introduction, Configuration – RCA THOMSON SpeedTouchTM (Wireless) Business DSL Router User Manual
Page 117: Scenario 3: metering, Chapter 9
Chapter 9
Scenario 3: Metering
E-NIT-CTC-20041213-0013 v0.5
115
9 Scenario 3: Metering
Introduction
To explain interface base metering we will take the setup from the previous scenario.
The total upload bandwidth availlable for this scenario is 512Kbps.
We reserved 50% of this bandwidth for EF traffic, meaning 256Kbps.
Now we would like to limit the bandwidth availlable for the Bronze group to 64Kbps.
Configuration
To configure this meter proceed as followed:
1
Go to the IP QoS page and select the Meter tab.
Expert mode -> IP Router -> IP QoS
Here you can add meters by clicking on the New button.
This will show you a configuration screen like shown in the figure above.
Now proceed as followed:
2
Set Name to
Bronze meter
.
3
Set Interface to
lan3
.
4
Set Label to
none
(we use interface based metering).
5
Set Drop rate to
64
.
6
Set Drop action to
drop
.
7
Set Mark rate to
60
.
8
Set Mark action to
mark
.
9
Set Burst size to
2
.
10
Set Marking to
disabled
.
11
Set Classification to
ignore
.
12
Set Class to
0
.
13
Click Apply to add the meter to the list.