Radio Shack 43-3595 - Manual (Page 8)

Installation
8
O N A D ESKTOP
1. Plug one end of the supplied long
modular cord into the TEL LINE jack on
the bottom of the base.
2. Insert the supplied AC adapter’s barrel
plug into the DC IN 9V jack on the
bottom of the base and route the
adapter’s cord through the strain relief
slot on the base.
" " " "
3. Plug the other end of the modular cord
into a modular phone line jack.
4. Plug the adapter into a standard AC
outlet.
I
NSTALLING THE
C
HARGING
C
RADLE
1. Insert the supplied
AC adapter’s
barrel plug into the
DC IN 9V jack on
the back of the
charger.
2. Route the cord
through the strain
relief slot and plug
the adapter into a
standard AC
outlet.
O N A W ALL
P LATE OR W ALL
To mount the main base directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on the
base. Drill two holes 3
15 / 16 inches apart.
Thread a screw into each hole, letting the
heads extend about
1 /
8
inch.
"
CAUTION
"
You must use
a Class 2
power source
that supplies
9V DC and delivers at
least 210 mA. Its center
tip must be set to
positive and its plug
must fit the phone’s DC
IN 9V jack. The supplied
adapter meets these
specifications. Using an
adapter that does not
meet these
specifications could
damage the phone or
the adapter.
!
DC IN 9V
43-3595.book Page 8 Monday, June 7, 2004 2:27 PM