Radio Shack 43-3595 - Manual (Page 33)

Additional Information
33
security code is set. Otherwise, return
to step 1 and try again.
ADDITIONAL
INFORMATION
I NSTALLING THE O PTIONAL
B
ELTCLIP
To attach the beltclip
Insert the beltclip into the holes on each
side of the handset. Press down until it
clicks.
To remove the beltclip
Pull both sides of the beltclip to release the
tabs from the holes.
H EADSET I NSTALLATION
You can connect an optional headset with a
3 /
32
-inch (2.5-mm) plug. Contact
RadioShack for a suitable headset.
To connect the headset, open the rubber
cover on the side of the handset. Then
insert the headset’s plug into the jack.Ô
When you finish using the headset,
disconnect it from the handset and close the
rubber cover to protect the jack.
Ô
NOTES
Ô
• If you place the handset
on the cradle to
recharge it while the
headset is connected,
be sure the handset
seats properly.
• You can use a handset
holder (available from
your local RadioShack
store) to hang the
handset on your belt for
greater convenience
when using a headset.
43-3595.book Page 33 Monday, June 7, 2004 2:27 PM