Radio Shack 43-3595 - Manual (Page 10)

Installation
10
3. Plug the battery pack’s connector into
the socket in the compartment (the
connector fits only one way). Place the
battery pack in the compartment.
4. Replace the cover.
To charge the battery pack, place each
handset on the base or charging cradle. The
CHARGE/IN USE and CHARGE indicators on
the cradles should light up. !
Recharge the battery pack when L L L Lo o o ow w w w
B B B Ba a a at t t tt t t te e e er r r ry y y y flashes on the display.Ô
When you first use the phone after charging
or recharging the battery pack, the phone
might not work and you might hear error
beeps. If this happens, place both handsets
on the main base.
Using a damp cloth, clean the charging
contacts on the handsets and cradles about
once a month.
About once a month, fully discharge the
battery packs by keeping the handsets off
the cradles until
L L L Lo o o ow w w w B B B Ba a a at t t tt t t te e e er r r ry y y y flashes on
each handset display. Otherwise, the
battery pack loses its ability to fully
recharge.
! IMPORTANT !
Be sure the battery pack is
properly connected before
you try to charge it. The
CHARGE/IN USE or
CHARGE indicator
illuminates when the
handset is on the cradle,
even if the battery pack is
not connected.
Ô
NOTES
Ô
• If the phone does not
work, recharge the
battery pack. (The
battery power might be
too low for the display to
operate.)
• If the battery pack
becomes weak during a
call, the handset beeps
and L
L L Lo o o ow w w w B B B Ba a a at t t tt t t te e e er r r ry y y y
flashes. When this
happens, you cannot
make a call on the
phone until you recharge
the battery pack.
• If the battery pack is
completely discharged
or the base loses power
while the handset is
away from it, place both
handsets on the main
base to re-register to the
main base.
43-3595.book Page 10 Monday, June 7, 2004 2:27 PM