Radio Shack 49-1000 - Manual (Page 26)

26
Beyond the Basics
Question Answer
What should I do if I lose
my remote control?
Re-register your complete system
to prevent someone else from using
the lost remote control.
Why do I hear a repetitive
trouble alarm when I try
to arm the system, and it
does not arm?
Check your Security Console’s
display. If a door or a window is
open, the zone # and the problem
displays.
Press disarm. Check each Door/
Window Sensor is working properly
and that no doors or windows are
open. Then, arm the system.
Or:
 While the trouble alarm is
sounding, press clear on your
Security Console to bypass the
problem zone (“BYPASSED”
displays.) Then, arm the system
again.
 Or, if the display shows
“TAMPER,” check the cover on
your Door/Window Sensor for
that zone.
 Or, check that the upper right
lid on your Security Console is
closed.
Why does my Motion
Detector cause false
alarms?
• All brands of motion detectors
sense motion by detecting
a change in temperature.
Therefore, do not place the
detector near any sources of
heat suchas over a heating vent
or an air conditioner.
• Do not place in a direct source of
bright light, such as sunlight.
49-1000 UG.indd 26 7/27/2004 6:49:55 PM