Radio Shack 49-1000 - Manual (Page 25)

25
Beyond the Basics
Frequently Asked Questions
Question Answer
Why can’t I arm my
system?
Your batteries may be low. Check
that the indicator on your Keychain
Remote turns on when you press
arm.
Replace the batteries and
re-register your Remote with your
Security Console if necessary.
Why does “PROBLEM”
and a Zone number
display when I try to arm
my system?
One of your sensors/motion
detectors has not reported during
the last four hours.
Check that the batteries in the
sensor/motion detector are good.
Or, a protected door or window is
open.
If you need to arm the system and
want to ignore a sensor/motion
detector that is not functioning:

Press clear on your Security
Console while the problem is
being displayed.
 Then, press arm on your
Keychain Remote. The problem
zone is not protected, but all
other zones are armed.
Why does the alarm sound
when I enter the house
before I have time to
disarm it?
You need to arm your system in the
“AWAY” mode.
Why don’t I hear a beep
from the Security Console
when I register a Remote?
You may have improperly registered
your remote.
Re-intialize and re-register your
Keychain Remote.
49-1000 UG.indd 25 7/27/2004 6:49:55 PM