Radio Shack 49-1000 - Manual (Page 20)

20
Beyond the Basics
if your security console is tampered with
If your system is armed and someone tampers with (opens the
cover on a Door/Window Sensor, the Motion Detector or the
Security Console), the alarm is tripped and a loud siren sounds. If
the system is not armed and someone tampers with a Sensor or
the Security Console, the word “TAMPER” appears in the display,
but the system does not trip. You must correct this by pressing arm
and then disarm before you can arm the system.
controlling lights and appliances
If you install one or more Lamp Modules (sold separately), you
can control lights around your home from your Security Console.
When it is in its normal state, your Security Console displays
“HOME CONTROL” in the display. You can simply press the number
button on the keypad that corresponds to the number set on the
module. Then, press On or Off on Security Console’s control panel
to control the light connected to the module.
You can also control lights set to your Security LIGHTCODEs from
the A and B buttons on the Keychain Remote. The A buttons on
the Keychain Remote control lights connected to Plug ‘n Power
Modules that are set to the Security LIGHTCODE you set in the
Console. The B buttons control modules set to the next sequential
number. For example, if you set your Security LIGHTCODE to 1,
the A and B buttons on the Keychain Remote will control Plug ‘n
Power modules that are set to Unit Codes 1 and 2. If your Security
LIGHTCODE is 10, the A and B buttons will control Modules 10
and 11. If your Security LIGHTCODE to 16, the A and B buttons
will control 16 and 1, etc. See page 16 to change your Security
LIGHTCODE.
Any lights set to your two Security
LIGHTCODEs flash on and off when the
alarm trips. They stay on after an alarm
until you turn them off, either from
your Security Console, or from your
Keychain Remote.
These lights also blink on for a second
when the alarm is armed in the HOME
Mode, or turn on for the exit delay
time when the alarm is armed in the
AWAY Mode.
49-1000 UG.indd 20 7/27/2004 6:49:40 PM