Renesas Single-Chip Microcomputer M37900T2-RPD-E - Manual (Page 29)

( 29 / 52 )
Chapter 4. Usage
This chapter describes from turning on the power of this product to starting up the emulator debugger.
4.1 Turning on Power ....................................................................................................................... 30
(1) Checking the Connection of the System ............................................................................... 30
(2) Turning on Power ................................................................................................................. 30
(3) LED Display When PC4701 Starts Up Normally ................................................................ 31
4.2 Downloading Firmware .............................................................................................................. 32
(1) When It is Necessary to Download Firmware ...................................................................... 32
(2) Downloading Firmware in Maintenance Mode .................................................................... 32
4.3 Starting up the Emulator Debugger (Setting EMEM Dialog) .................................................... 33
(1) Processor Mode..................................................................................................................... 33
(2) Emem Address ...................................................................................................................... 33
(3) ROM Address ....................................................................................................................... 33
(4) DMA Address ....................................................................................................................... 33
(5) 8-bit bus mode Address ........................................................................................................ 33
(6) Map Address ......................................................................................................................... 33
4.4 Self-check ................................................................................................................................... 34
(1) Self-check Procedure ............................................................................................................ 34
(2) If an Error is Detected in the Self-check............................................................................... 35