RCA VR643HF - Manual (Page 26)

24
VCR Basics
Playing a Tape
1. Tune the TV to your VCR viewing channel
(3, 4, or TV’s video input).
2. Insert a tape in the VCR.
POWER
EJECT CHANNEL TRACKING
TV•VCR
INPUT RECORD STOP PAUSE
FWD REV PLAY•PAUSE
If the Auto Play feature is set to ON, the tape automatically
begins playback (if the safety tab on the cassette is removed).
• Press FORWARD or REVERSE to position the tape.
• Press PLAY (if necessary) to begin tape play.
• Press PAUSE for stop action.
• Press TRACKING up or down to remove any streaks from the
picture, if necessary.
• Press STOP to stop playback.
Automatic Rewind
The VCR automatically rewinds the tape if it reaches the end of
the tape during playback. While rewinding, you can press
POWER on the VCR (OFF on the remote) and the VCR will turn
off after rewinding.
Automatic Tracking
The VCR has automatic tracking which
adjusts the picture when playing back
a tape recorded on another VCR.
Automatic tracking is turned on
whenever a tape is inserted or the
VCR’s power is turned on.
Pause
If you pause, the VCR automatically
switches from pause to stop after a
few minutes to reduce tape wear.
Numbers (0 through 9) Select a channel up to 99 by pressing
two numbers. Select a cable channel over 99 by pressing and
holding 1 until 1 – – appears on the screen. Then press the other
two numbers.
OFF Turns the TV off.
VOL Up and Down Raises and lowers sound of TV.