RCA VR648HF - Manual (Page 28)

Chapter 4: On-Screen Menus
28 Chapter 4
Add/Remove Channels
Your VCR may come with a list of channels preset at the factory.
Even though it may come with such a list, you may want to add or
delete certain channels.
Note: If you use a cable box to view all channels, this step is not
necessary.
To go to the channel you want to add or remove, use the remote
control’s CHAN up or down buttons or enter a specific channel
number using the number buttons.
To remove a channel from the channel list, press CLEAR. To add a
channel to the channel list, press INFO.
Note: To view active channels, use the remote control’s CHAN up
and down buttons. You can also access channels that aren’t
available in the active channel list by using the remote control’s
number buttons to enter the specific channel number.
Signal Type
This feature is useful if your cable signal goes out; it allows you to
switch to a regular antenna for alternate television reception.
From the Channels menu, choose between Signal Type: Cable or
Antenna by pressing the 3 button until the correct signal type is
shown.
Cable Box Setup
This setup applies only when all channels are received through a
cable box. Cable box setup is explained in detail on page 9.
CABLE BOX SETUP
Do you use your cable
box to receive ALL
channels or only SOME
channels?
1 ALL channels
2 Only SOME channels
3 Cancel setup
ADD/REMOVE CHANNELS
Channel 115
is presently ADDED
Press CLEAR to remove
Press MENU to exit
If you press MENU, the
VCR output channel
switches to channel 4.
VCR Output Channel
Use this option to change the VCR’s output channel. The default is
channel 3. To change the output channel to channel 4, press the
MENU button. If you change the output channel to 4, you must tune
your TV to channel 4 to watch channels through the VCR or play a
tape.