Main menu, Input source, Aspect ratio – Runco PL-61DHD User Manual
Page 43: Pre l iminar y
Runco PlasmaWall Owner’s Operating Manual
33
PRE
L
IMINAR
Y
Main Menu
The Main Menu is the starting point for accessing all display functions.
(The Calibration and Service menus are hidden and not accessible until you enter a
passcode.)
Input Source
From the Main Menu, select Input Source to choose a video signal source.
The active source is indicated by an arrow (>) to its left; in the example at left, Composite
is the active source.
Aspect Ratio
To change the aspect ratio (size and shape) of the projected image, select Aspect Ratio
from the Main Menu and press ENTER. Select the appropriate aspect ratio for your
screen size and the type of program material being viewed; refer to Table 4-1.
The currently-selected aspect ratio is indicated by a “
7
” to its left; in the example at right,
Anamorphic is selected.
Runco Video
Input Source
Aspect Ratio
Picture
Input Position
ISF Presets
Information
Calibration
Service
Input Source
>
Composite
S-Video 1
S-Video 2
Component SD
HD/RGB 1
HD/RGB 2
DVI 1
DVI 2
HD Pass Thru 1
HD Pass Thru 2
1. HD Pass Thru 1 and HD Pass Thru 2 are available only when the
Display Device Input Source is set to RGB (refer to
2. Selecting HD Pass Thru 1 or HD Pass Thru 2 loops the
HD/RGB 1 or HD/RGB 2 input signal respectively to the RGB
output. This prevents display of the on-screen menus. To switch
from HD Pass Thru 1 or 2 to another source, use the direct
access buttons on the remote control, or the left- or right-arrow
buttons on the DHD Controller.
Note
Aspect Ratio
7
Anamorphic
Standard 4:3
Letterbox
VirtualWide
Cinema
When you change the aspect ratio, save the change to a preset
afterwards. Otherwise, the change will be lost when a different
input is selected. (The aspect ratio is saved for each input and
resolution separately.) For information about saving settings, refer
to
Note