Runco PL-61DHD - Manual (Page 39)

Runco PlasmaWall Owner’s Operating Manual 29
PRE
L
IMINAR
Y
4.1
Turning on the Power 1. Turn on your source components.
2. Attach the two ferrite cores supplied with the display to each end of the AC power
cable as shown in Figure 4-1. Doing so will reduce radio frequency interference (RFI)
emissions to a level that conforms to FCC regulations. Use the supplied plastic bands
to secure the cores in place.
Figure 4-1. Attaching the Ferrite Cores to the Power Cable
3. Plug the female end of the power cord into the AC receptacle on the rear of the
PlasmaWall (AC 100V ~ 240V). Connect the other end to your AC power source.
4. Similarly connect the DHD Controller to a nearby AC outlet.
5. Press the POWER button on the underside of the PlasmaWall. Its power indicator
lights green.
6. Turn on the main power switch at the rear of the DHD Controller.
7. Press the ON button on the remote control to
turn on the DHD Controller (or press the power
button on the front of the DHD Controller). The
power indicator on the DHD Controller lights
solid blue.
8. After a brief warm-up period (approximately 10
seconds), the PlasmaWall will display an image.
4. Operation
Power cable
Ferrite Core
Ferrite Core