2 filter replacement, Filter replacement, Pre l iminar y – Runco VX VIDEO XTREME VX-33D User Manual
Page 78
Maintenance and Troubleshooting
62
Runco VX-33d Installation/Operation Manual
PRE
L
IMINAR
Y
6.
Install the new lamp module.
7.
Replace the lamp cover and re-tighten all
screws.
5.2
Filter Replacement
Whenever you replace the lamp – or more often if the projector is installed in an extremely
dusty environment – you should also replace the filter located at the right side of the
projector.
1.
Loosen the four captive screws
holding the filter access panel in
place. Then, remove the panel.
2.
Pull the filter out of the projector
and discard. Do not reuse filters.
3.
Insert the new filter with the pleats
facing in and the foam-covered
side facing out.
4.
Replace the filter access panel and
tighten the screws to secure it.
Side Filter
Access Panel
See also other documents in the category Runco Projectors:
- CL-510 (36 pages)
- Video Xtreme VX-44d (114 pages)
- VX-4c 720P (2 pages)
- VX-55D (120 pages)
- VX-5C (2 pages)
- VX-80d (108 pages)
- SC-1 (122 pages)
- Reflection (72 pages)
- REFLECTION CL-510LT (36 pages)
- VX-2c (36 pages)
- VX-50d (108 pages)
- CL-700 (2 pages)
- SC3300W (2 pages)
- DIGITAL LIGHT PROCESSING VX-2000D (90 pages)
- VX-1000d (76 pages)
- VX-5000ci (43 pages)
- DTV-873 (2 pages)
- VX-6c (110 pages)
- VIDEO XTREME VX-22D (90 pages)
- VX-2i (60 pages)
- 61SBX59B (72 pages)
- VIDEO XTREME VX-60 960p (2 pages)
- Vision 85 (88 pages)
- CL-610LT (56 pages)
- Video Xtreme VX-2000d (90 pages)
- DLC-2000HD (2 pages)
- VX-33I (92 pages)
- CL-610 (76 pages)
- Video Xtreme VX-2ix (80 pages)
- CINEWIDE VX-6000D (112 pages)
- VX-5000d (6 pages)
- VX-3C (2 pages)
- 1080p (114 pages)
- VIDEO XTREME VX-22I (88 pages)
- VIDEO XTREME VX-33I (92 pages)
- VX-4c (110 pages)
- VX-2000d (88 pages)
- DR-300c (2 pages)
- CL-810 CL-810 Ultra Cl-810 CineWide CL-810 / SDC-1 (76 pages)
- DTV-992 (69 pages)
- CL-810 (58 pages)
- Reflection MBX-1 (2 pages)
- Video Xtreme VX-6000d (102 pages)
- DR-300 (2 pages)