Pre l iminar y – Runco VX VIDEO XTREME VX-33D User Manual
Page 58
42
Runco VX-33d Installation/Operation Manual
PRE
L
IMINAR
Y
2.
Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate or fixed
CineWide Base Plate (item #7). Position the bracket so that the long slot at the bottom
of the lens holder is perpendicular to the corresponding slots on the plate.
3.
Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers
(item #6) and Yaw/X Adjustment Levers that you removed in Step 1.
4.
Use the Lens Mounting Screws to attach the Lens Adapter Ring (item #1) to the Pitch
Adjustment Yoke (item #2); see Figure 3-20. (Use the round, threaded holes on the
yoke.)
5.
Use the Height/Y Adjustment T-Screws (item #3), Pitch Adjustment T-Screws
(item #4) and T-Nuts (item #9) to attach the Pitch Adjustment Yoke and Lens Adapter
Ring to the Anamorphic Lens Holder. The Yoke should be as close to the primary
lens as possible.
6.
Attach the lens to the Lens Adapter Ring by threading it clockwise.
Figure 3-20. Attaching the Anamorphic Lens to the Lens Adapter Ring
Lens threads into ring
FO
CU
S