Runco VX VIDEO XTREME VX-33D - Manual (Page 32)

Installation
16 Runco VX-33d Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the VX-33d installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 17
2 Install the primary projection lens 22
3
If installing a VX-33d/CineWide or VX-33d/CineWide
with AutoScope: Install fixed CineWide base plate or
AutoScope lens motor 24
4 Mount the projector 28
5 Connect the DHD Controller to the projector 29
6 Connect signal sources to the DHD Controller 31
7 Connect external controller to RS-232 port (optional) 36
8
Connect 12-volt trigger outputs to AutoScope lens motor
and/or other equipment (optional) 37
9
Connect projector, DHD Controller and lens motor (if
present) to AC power and power up 38
10
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation 39
11
Primary lens adjustments: projected image size (zoom),
position (shift) and focus 19, 40
12 Install CineWide anamorphic lens (optional) 41
13
CineWide lens adjustments: position, pitch (angle),
geometry and focus 43
14
Projector calibration: adjust the following for each input;
save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position 49 through 56
Note