RCA RP-3761 - Manual (Page 5)

THE DIGITAL CD CLOCK RADIO
Protection against mains power
failures:
-- Connect a 9-volt battery
(IEC 6LR61 or NEDA 1604A)
-- When the battery is used up, the digits
flash on and off when the power comes
back on
Battery compartment at
the backside of the unit
NOTE: Alkaline (IEC 6LR61/NEDA 1604A) batteries are recommended.
Carbon-zinc battery may be used but memory holding time will be substan-
tially reduced. Memory holding time for a fresh alkaline battery is approxi-
mately 8 hours (if radio or alarm are not operated) which should take care of
short, nuisance-type AC power failures. To preserve battery life, the unit
should remain plugged into an AC outlet. As the battery gets older, its voltage
drops and memory may be lost. Be sure to replace the battery periodically.
Battery should be removed if the unit will be stored for more than one month.
Leaky battery can badly damage the clock radio.
Setting time
Press and hold
2
Press or
1. Press and hold or to skip fast
2. The AM LED indicator will light to show AM time
2
TIME SET
Adjusting display brightness
You may slide on the left side of the unit to vary the LED
display brightness. When you slide to OFF, the display will be
manintained at the brightness level; slide to ON, the display will vary
automatically according to the environment.
1
OFF DIMMER ON
2
RP3761 7/20/00, 3:18 PM 6