Roland F-90. - Manual (Page 7)

7
Introduction
3. Firmly tighten all of the screws and stand the
instrument back up.
When lifting the instrument back up, grasp near the
center of the speaker box and the F-90, and gently raise
the instrument.
fig.st03-2
If the Stand is Uneven
If after lifting the F-90 back up you find that stand is
crooked, try loosening the screws and then securing
them again. When retightening, start with the top
screws, then work your way down. When doing this,
slightly loosen the screws before firmly tightening them.
4. Place the caps over the heads of the screws (four
on each side).
fig.st03
5. Connect the speaker cable extending from the
rear of the speaker box to the F-90’s speaker
connector.
Press the speaker cable completely into the connector so
that it is securely fastened.
fig.st04
When Moving the Instrument
Disconnect the AC cord, cables and the music stand from the
F-90.
Then lift the piano while keeping it level, and move it with
care, so that you do not drop it on your feet, or get your
hands caught.
When Disassembling
Disassemble the unit by carrying out assembly Steps 1-5 in
reverse order.
When Changing the Orientation of the
Speaker Box
Be sure to completely disassemble the unit, change the
speaker box orientation, then reassemble it.
Caps
F-90 Rear
Hold and insert the cable so that the clip
portion extends into the stand and is
securely connected.
Speaker cable
Speaker Connecter Clip Portion