Runco PlasmaWall XP-50DHD - Manual (Page 55)

Operation
PlasmaWall XP Series Owner’s Operating Manual 43
PRE
L
IMINAR
Y
Overscan: Image Overscan pushes the outside edge of the active picture area of the
video signal out beyond the edge of the display area.
Some television programs are produced based on the assumption that older television
sets may not display the outer edges of the broadcast picture area. Over scan effectively
trims away these inactive, outer edges and enlarges the remaining portion of the image to
fill the display area.
Select from 1% to 10% of Overscan, as desired.
For HDTV, DVDs and other video sources, Overscan is generally not necessary or
desirable.
Memory Presets For each input, the PlasmaWall lets you save image quality settings as presets that you
can recall at a later time. You can create up to four presets per input and resolution. Use
the Memory Presets menu to recall saved image presets, or to save image settings in the
“Custom 1” or “THX” (“Custom 2” on some models) memory location. The
currently-selected preset is indicated by a “
7
” to its left; in the example shown here, ISF
Night is selected.
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Brightness
• Contrast
• Color saturation
• Tint
• Sharpness
To reset the Custom 1 and THX (Custom 2) image presets to their factory defaults, select
Factory Default and press ENTER.
Information Select Information from the Main Menu to see information that uniquely identifies your
display: its serial number, the installed hardware and firmware versions and the firmware
version build date. Should you ever need to contact Runco Technical Support, this
information will help them answer your questions or resolve product performance issues.
Memory Presets
7
ISF Night
ISF Day
Custom 1 Save
THX (Custom 2) Save
Factory Default
Information
Serial Number
Hardware 0
Firmware 0100.075B
Date Nov 1 2007