Runco PlasmaWall XP-50DHD - Manual (Page 29)

Installation
PlasmaWall XP Series Owner’s Operating Manual 17
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the PlasmaWall installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, refer to
page...
1 Mount the PlasmaWall on a wall, table stand or floor ped-
estal 18
2 Connect the DHD Controller to the PlasmaWall 22
3 Connect signal sources to the DHD Controller 25
4 Connect external controller to DHD Controller RS-232 port
(optional) 29
5 Apply power to the PlasmaWall 33
6 If using the PlasmaWall with a computer, adjust computer
display properties 33
7 Display calibration: adjust the following for analog inputs;
save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance 37
8 Repeat Step 7 for digital inputs 48
Note