Runco PlasmaWall XP-50DHD - Manual (Page 45)

PlasmaWall XP Series Owner’s Operating Manual 33
PRE
L
IMINAR
Y
4.1
Turning on the Power 1. Turn on your source components.
2. Press the main power switch on the PlasmaWall (see Figure 2-1, Figure 2-2 or Figure
2-3). The standby/on indicator lights green.
3. Set the main power switch at the rear of the DHD Controller (see Figure 2-6) to the “on”
position.
4. Press the ON button on the remote control to
turn on the DHD Controller and PlasmaWall (or
press the power button on the front of the DHD
Controller). The power indicator on the DHD
Controller lights solid blue.
5. After a brief warm-up period (approximately 10
seconds), the PlasmaWall will display an image.
4.2
Setting the Computer
Display Properties To maximize image quality when using the PlasmaWall with a personal computer, you
may need to adjust the display properties of your computer’s video card. To do this on a
Microsoft® Windows®-based PC:
1. Choose Settings from the Windows Start
Menu and click on “Control Panel.”
4. Operation