Renesas SuperH SH7339 - Manual (Page 11)

5
Pin 1 mark
25.0
23.0
6 x 2.54 = 15.24
(2.54)
0.45
Pin 1
Pin 8
Pin 7
Pin 14
Pin 1 mark Unit: mm
H-UDI port connector (top view)
H-UDI port connector
(top view)
Pin No. Signal
1
2
3
4
5
6
7
8
9
11
10, 12,
and 13
14
TCK
/TRST
TDO
/ASEBRKAK
TMS
TDI
/RESETP
/CA
(GND)
UVCC
GND
Input/
Output*
1
*2
*2
*2
GND *3 Output
Input
Input
Output
Output
Input
Input
Output
Output
Output
Note
User reset
*2
*4
Notes: 1. Input to or output from the user system.
2. The slash (/) means that the signal is active-low.
3. The emulator monitors the GND signal of the user system and detects whether or not
the user system is connected.
4. The /ASEMD0 pin must be 0 when the emulator is connected and 1 when the emulator is
not connected, respectively.
(1) When the emulator is used: /ASEMD0 = 0
(2) When the emulator is not used: /ASEMD0 = 1
To allow the /ASEMD0 pin to be GND by connecting the user system interface cable,
connect pin 22 directly to the /ASEMD0 pin. Do not ground the pin.
SH7339
Pin No.
J2
L2
L3
N2
K3
K4
F5
H3
Figure 1.2 Pin Assignments of the H-UDI Port Connector (14 Pins)