Changing the midi settings, P. 48), Data. (refer to p. 48) – Roland V-GUITAR VGA-7 User Manual
Page 48
48
Appendices
Changing the MIDI Settings
When using MIDI to control the VGA-7, you can change the settings for the MIDI parameters as needed.
1. While holding down [SYSTEM], turn on the POWER switch.
2. Use [PARAMETER ▼/▲] to select MIDI parameters.
3. Press [SELECT/VALUE ▼/▲] to set the value.
4. Press either [TUNER], [VARIATION/EDIT], [GK], or [SYSTEM] to stop the operation.
* If two or all of “6 TUNER,” “d PRESET/USER,” and “E MANUAL/MEMORY” are set to the same controller number, control will be
given priority in the order of 1: 6 TUNER, 2: E MANUAL/MEMORY, and 3: d PRESET/USER, and control of the remaining
parameter(s) will be disabled.
With the foot volume and the WAH controller number both set to the same number, you can use a single expression pedal to
control both the volume and the wah effect, the pedal acting as a wah pedal when the WAH effect is on, and as a volume
pedal when the wah effect is off.
Parameter No.
Value
Factory
Setting
Setting
for FC-200
1
MIDI CH (Setting for MIDI channel)
1–16
1
1
2
OMNI (Setting for Omni mode)
On, OFF
On
On
3
DEVICE ID (Setting for Device ID)
1–32
1
1
4
Foot Volume (Controller No.)
1–31, 64–95
7
7
5
WAH (Controller No.)
1–31, 64–95
7
7
6
TUNER (Controller No.)
1–31, 64–95
80
80
7
EFX (Controller No.)
1–31, 64–95
65
65
8
DELAY (Controller No.)
1–31, 64–95
66
66
9
CHORUS (Controller No.)
1–31, 64–95
67
67
A
REVERB (Controller No.)
1–31, 64–95
68
68
b
TAP (Controller No.)
1–31, 64–95
69
69
c
CAPO (Controller No.)
1–31, 64–95
70
70
d
USER/PRESET (Controller No.)
1–31, 64–95
75
75
E
MANUAL/MEMORY (Controller No.)
1–31, 64–95
64
76