Roland V-GUITAR VGA-7 - Manual (Page 20)

20
TUNER
Here’s how to use the VGA-7’s tuner function to tune your guitar.
In order to use the tuner, you must first make tuner settings.
Setting the Tuner
Press [SYSTEM], getting the indicator to light, and then make
the following settings.
fig.15
When you have finished making settings, press [SYSTEM]
once again, extinguishing its indicator.
Specify the standard pitch
(1 PITCH)
* With the factory settings, this is set to “440 Hz.”
1. Press [PARAMETER ▼/▲] until “1” is shown (blink) at
the left of the display.
This selects “1 PITCH.”
2. Press [SELECT/VALUE ▼/▲] to set the standard pitch.
* The example display shows that the standard pitch is set to 440
Hz.
fig.16
Setting the output level of the
tuning sound (2 LEVEL)
* At the factory settings, this is set to 0 (MUTE: sound will not
be output during tuning).
1. Press [PARAMETER ▼/▲] until “2” is shown (blink) at
the left of the display.
This selects “2 LEVEL.”
2. Press [SELECT/VALUE ▼/▲] to set the output level.
fig.17
Display Setting
35–45 435 –445 Hz
1 2
Display Setting
0–10 0 (MUTE: sound will not be output during
tuning)–10
1 2