Roland V-GUITAR VGA-7 - Manual (Page 39)

39
System setting
Foot Switch (FOOT SW)
Specify the operation of the foot switches connected to the
EFX–REVERB jacks.
* You cannot change the settings for each individual jack.
Parameter Number: 4 TYPE
Display Setting
1 EFFECTS (MOMENTARY):
The effect on/off state specified by the patch
will be reversed. If the effect is on, it will be
switched off
→ on → off → on... when the
switch is pressed. If the effect is off, it will be
switched on
→ off → on → off... when the
switch is pressed.
* Connect a momentary-type foot switch
(sold separately: BOSS FS-5U).
2 EFFECTS (LATCH):
The foot switch’s current status is the one used,
regardless of the Patch’s effects status (on/off).
* When this setting is selected, the effects cannot be
turned on and off with the buttons on the front panel.
* Connect a latch-type foot switch (sold separately:
BOSS-FS-5L). Be sure to connect the FS-5U to the
DELAY jack’s RING.
3 PROGRAM:
Manual and Memory are switched using a foot
switch connected to the EFX jack, while you can
switch Patches when the foot switch is
connected to the DELAY, CHORUS, or REVERB
jack.
* Connect a momentary-type foot switch
(sold separately: BOSS FS-5U).
* With the factory settings, this is set to
“1 EFFECTS (MOMENTARY).”
Expression Pedal (EXP PEDAL)
Specify how the expression pedal will behave when the
patch is changed.
Parameter Number: 5 PEDAL HOLD
Display Setting
1 ON:
When the patch is changed, the volume will be
as specified by the position of the pedal.
2 OFF:
When the patch is changed, the volume will be
as specified by the [VOLUME] setting of the
COSM amplifier, regardless of the position of
the pedal.
* With the factory settings, this is set to “1 ON.”