RocketFish RF-RBWSO2 - Manual (Page 24)

24
Rejoining your sender and speaker
In case you need to re-join these devices (this operation is not
necessary out of the box as these devices are already joined at the
factory). To rejoin your Sender and Wireless speaker (this assumes
you do not have any other Rocketboost products or the Sender is
your hub for your Rocketboost network) please make sure the hub
switch is set to Enable.
To re-join your Sender and Wireless speaker:
1 Make sure that the Hub switch on the sender/receiver is set to Enable,
then connect the AC and hold the power button down for three seconds
until the Power LED blinks green rapidly.
2 Power up the wireless speaker and press the Power button until the
Power LED blinks rapidly. After a few seconds both LED lights should
illuminate solidly indicating a successful link has been established
between the devices.
Using two wireless speakers as a stereo pair
Your Wireless speaker supports an easy to use stereo mode in the
event you decide to buy a second speaker.
To join a second wireless speaker to the network in a stereo configuration:
1 Join the first Wireless Speaker to your network (if it is already connected
skip to step 2). If you are unsure how to do that refer to the instructions
above.
2 Tune to the source that you wish to listen to on the first Wireless speaker.
3 Join the second wireless speaker to the network.
4 Tune the second wireless speaker to the same source, you will now have
two mono speakers which will be indicated on the LED front panel of
each device.
5 Select which speaker you wish to be the left speaker and press and hold
the source button for 5 seconds. It will start blinking rapidly.
6 On the other Wireless speaker press and hold the Source button for 5
seconds and it will blink rapidly and then turn solid. The LED indicators
will then show the appropriate Left and Right indication for each
speaker.
7 The autosensing technology in Rocketboost will automatically switch
the speaker to Mono if only one speaker is powered up, however when
the second speaker is then powered up the stereo settings will take
effect.
RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 24 Thursday, August 27, 2009 7:39 PM