23 rf-rbws02 – RocketFish RF-RBWSO2 User Manual
Page 23
23
RF-RBWS02
5
Perform the same steps to join the wireless speaker. Put your existing
hub in joining mode and then put the speaker in joining mode by
pressing and holding the power button on the speaker.
The Tx LED lights when an input signal is connected, and does not light if
a signal is not connected (when a 3.5 mm jack is connected, the
transmitter is automatically enabled).
Note: When a link is established between the sender/receiver and wireless speaker,
and an audio source signal is transmitted from the sender/receiver to the speaker, the
SOURCE indicator on the wireless speaker will light solidly blue.
CHARGE
BASS
POWER /JOIN
CHANNEL
L - MONO - R
SOURCE
TM
Power on LED
Tx LED
RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 23 Thursday, August 27, 2009 7:39 PM