RocketFish RF-RBWSO2 User Manual

Page 22

To use the unit as a sender with another node as the hub (only follow these instructions
if you have an existing Rocketboost network. Otherwise skip to the Listening to Music
section):

Set the HUB STATUS switch to DISABLE.

Important

: Make sure that the HUB STATUS switch is set to

DISABLE before the

sender/receiver is turned on.

• The power-on indicator LED lights blue when the HUB STATUS

switch is set to DISABLE.

Press and hold the

button on the sender/receiver for more than three

seconds to put it into joining mode for 30 seconds.

• The power-on LED on the sender starts blinking rapidly.

• The power-on LED lights steadily if the link is activated between both

of the units.

• The power-on LED blinks at a slower rate if the communication link is

not successful.

While the power-on LED on the sender is blinking rapidly, press the

Power button on the hub device for three seconds to put it into joining

mode. If successful, both lights will illuminate solidly. If the sender light

blinks slowly, retry the process.

If the source LED is not lit, press the Source button on the

sender/receiver to toggle to the next channel. If the LED still does not

light, make sure that the source is powered up.

Power
on LED

RF-RBWS02_09-0535_MAN_ENG_V1.fm Page 22 Thursday, August 27, 2009 7:39 PM