The hardware installation procedure – RCA 300 Series User Manual
Page 22

2 SpeedTouch™ Installation
E-SIT-CTC-20030702-0003 v4.0
20
6
The installer copies the necessary files to your computer.
7
The following screen appears:
Click OK to proceed.
8
At the end of the procedure, the following window appears:
Click Restart to finish the installation and restart your computer.
The hardware
installation procedure
After restarting your computer, proceed as follows:
1
Use the ADSL cable provided to wire the SpeedTouch™ ADSL port to your tele-
phone wall outlet or distributed filter.
2
Insert the SpeedTouch™'s USB connector into the computer's USB port.
A USB port can be easily located, it is marked with the typical USB symbol:
.
Note
You can also connect your SpeedTouch™ to the computer via a USB
hub.
3
On the Apple menu, point Control Panels and click Modem:
4
The Modem control panel appears
Make sure the SpeedTouch™ is selected in the Connect via list and Modem list.
Note
If you are using an RFC1483 Bridged connection you may only have to
adjust the Modem list selection.