Installer, Installation menu – Russound CAV6.6 User Manual

Page 52

INSTALLER

INSTALLATION MENU

Key Config (cont’d.)

2. SOURCE NUM –

Select the source the key will be configured for.

(Src #)

3. SELECT A KEY –

Using

, select the keypad key to be configured.

(SelKy)

4. KEY TYPE –

Either “Key Press,” “Key Hold” or “Both” will activate the command.

(KeyTp)

5. KEY NAME –

Name that appears on the keypad display when the command is

(KeyNm)

activated.

6. COMMAND TYPE –

Select the type of source command (e.g., CD, TV, etc.).

(CmdTp)

a. Selected: Learned IR –

Choose Learned IR if the pre-programmed IR code library does

(LrnIR)

not support the source component.

i. LEARNED SRC –

Select the learned source bank to be assigned to the source

(LnSrc)

component. Procedure advances to KEY FUNCTION (step 8)

b. Selected: Unassigned

The key configuration is cleared. Procedure advances to SAVE

(Unasg)

CHANGES (step 9)

c. Selected: Default

Default selects the same device type and device code previously

(Deflt)

setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 8)

d. Selected: Macro:

(To build macros, see Macro Editor page 60)

i. MACRO -

Macro loads a series of commands which are processed when

(Macro)

activated.

ii. MACRO ID –

Enter the macro ID number. Menu advances to SAVE CHANGES

(MacID)

(step 9)

e. All Other Selections:

Procedure advances to DEVICE CODE (step 7)

7. DEVICE CODE –

Enter source component code number listed in this manual’s

(DevCd)

Reference section.

8. KEY FUNCTION –

Select a function for the button.

(KeyFn)

9. SAVE CHANGES? –

Select “yes” to save changes. Procedure advances to ZONE NUM

(Save?) (step