Radio Shack 43-3537 User Manual

Page 6

You can also dial the number before you
press

TALK

. If you make a mistake, press

DEL/CH

until the incorrect entry is erased,

then enter the correct number. To delete the
entire number, hold down

DEL/CH

When you receive a call,

?dYec_d]

9Wbb

appears. To answer the call, lift the handset
and press

TALK

. If Auto Talk is on, just lift the

handset. If the handset is away from the
base, press

TALK

, any number,

∗∗∗∗

/TONE/

JWba

appears on the handset’s

display. To end a call, place the hand-set on
the base or press

END

'.'%6+0)

6*'

*#00'.

The phone has 20 channels. If the call
disconnects or you experience difficulty
hearing the conversation, press

DEL/CH

the handset to select a different channel.

IYWdd_d]

appears as your phone searches for

a clear channel.

&,756+0)

6*'

#0&5'6

1.7/'

To adjust the volume of the sound you hear
through the handset during a call, press

on the handset until you reach the desired

volume level.

Lebkc[

CWn_ckc

Lebkc[

>_]^

Lebkc[

C[Z_kc

, or

Lebkc[

Bem

appears on the

handset. Once you set the volume level, the
setting is maintained even after you hang up
the phone.

5+0)

'&+#.

You can quickly dial the last number you
dialed. Lift the handset and press

RDL/

PAUSE

, then

TALK

. The phone dials the

number.

±ý

059'4+0)

#..

#+6+0)

#..

Pressing

TALK

during a call performs the

electronic equivalent of a switchhook
operation for special services, such as Call
Waiting. For example, if you have Call
Waiting, press

TALK

to answer an incoming

call without disconnecting the current call.
Press

TALK

again to return to the first call.

If you do not have any special phone
services, pressing

TALK

might disconnect the

current call.

76+0)

6*'

+0)'4

To temporarily mute the ringer’s tone when
you receive a call with the handset off the
base, press

END

. Ringer mute automatically

turns off when you receive another call.

610'"5'48+%'5"10"#"

27.5'".+0'

Some special services require tone signals
(such as bank-by-phone). If you have pulse
dialing, you can still use these special tone
services.

Dial the service’s main number. When the
service answers, press

∗∗∗∗

/TONE/

. Any

additional numbers you dial are sent as tone
signals. The phone’s dial mode resets to
pulse when you make or receive a call.

2#)+0)

To send a page from the base to the handset
or to locate the handset when the phone is
not in use, press

PAGE

on the base. The

handset beeps for about 1 minute.

FW]_d]

appears on the handset while the page
sounds.

To stop the page, press any key on the
handset, place the handset on the base, or
press

PAGE

on the base again.

The phone rings when a call comes in while
you are using the page feature.

75+0)"#"*'#&5'6

You can make or answer calls with hands-
free convenience using an optional headset
that has a

-inch (2.5-mm) plug.

RadioShack has a variety of headsets
available.

To connect the headset, gently flip open the
rubber headset jack cover on the side of the
handset, then insert the headset’s plug into
the jack.

Connecting a headset disconnects the
handset’s earpiece and microphone.

on the handset also controls the

headset’s volume.

With a headset connected, you can make or
answer calls as usual using the keys on the
handset.

When you finish using the headset,
disconnect it from the handset and close the
rubber cover to protect the jack.

/'/14;"&+#.+0)

You can store up to 10 phone numbers and
names in memory, then dial a stored number
by entering its memory location number.
Each number can be up to 20 digits, and
each name can be up to 14 characters.

"016'"

Adjusting the Handset’s Volume

When you press

while the volume is

maximum or

while the volume is low, the

setting does not change. The phone sounds
three short beeps.

Using Redial

•

You can also press RDL/PAUSE after
pressing TALK.

•

The redial memory holds up to 32 digits, so
you can redial long-distance as well as local
numbers.

•

The redial memory also holds pause entries
(see “Entering a Pause” on Page 7).

Using a Headset

•

If you place the handset on the base to
recharge it while the headset is connected,
be sure the handset seats properly.

•

You can use a handset holder (available
from your local RadioShack store) to hang
the handset on your belt for greater
convenience when using a headset.