Ricoh Monochrome PoCl Camera Link Camera FV-L030B1 User Manual

Page 26

26/32

FV-L030B1
User’s Guide Rev. 1.01

Command No.

Command Descriptions

12H:

MOD3[7

[Camera function mode setting 3] Initial data: 0

Sets the following camera function modes.

D[7

D7~D6: Video Out

00: 10bit

01: 8bit

10: 12bit

11: No function (Prohibited setting. Do not set these values)

D5:

Trigger-in connector selection

0: Camera Link (CC1)

1: /IO connector (No.2 Pin)

D4~D3: Exposure Start Mode

00: Normal

01: Reserved trigger

10 ~11: H reset

D2~D1: No Function

Set always “000”

Look-up table (Gamma)

00: OFF

01: ON

14H:

UART[7

[Communication mode] Initial Data: 01H

Sets the communication modes.

D[7

D7~D2:

No Function

Set always “000000”

D1~D0:

Communication Mode

00: 38,400 bps

01: 9,600 bps

10: 57,600 bps

11: 115,200 bps

1CH:

AGCMAX[7..0]

[AGC maximum limit] Initial data: 255, data range: 0 to 255

Sets the maximum limit for the AGC.

1DH:

ALCTRGT [7..0]

[Target Brightness for ALC] Initial data: 128, data range: 0 to 255

Sets the target brightness for the ALC function (Auto Luminance Control).

1EH:

ALCMODE[7..0]

[ALC mode] Initial data: 0

Sets the ALC modes.

D[7

D7:

Long exposure

0: OFF

1: ON

D6 to D2

No Function

Set always “00000”

AGC (Auto Gain Control)

0: OFF

1: ON

AE (Auto Exposure)

0: OFF

1: ON

When using AE combined with the long exposure, exposure time is controlled regardless of the frame rate.

Therefore, the frame rate varies depending on the exposure time.