Roberts Radio RecordR User Manual

Page 42

System reset

If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.

1. Ensure your radio is switched on. Press and hold the Info button.

2. Press and release the Tuning Up or Down buttons until 'Factory

Reset' appears on the display. Press and release the Select button.

3. Press and release the Tuning Up or Down buttons until 'Yes' appears

on the display. If you do not wish to carry out a system reset, highlight
'No' and then press the Select button. The display will revert to the
previous display.

4. With

'Yes' displayed, press and release the Select button. A full reset

will be performed. The station list and presets will be erased. Timers
and alarms will be cancelled and sleep and nap timer settings will be
set to their default values. The display will show 'Welcome ROBERTS'
and after a few seconds a station scan search will be performed
automatically. The display will show progress of the station search.
The number on the right of the display is the number of stations that
have been found.

In case of malfunction due to electrostatic discharge, reset the product as
above to resume normal operation.
It may be necessary in some cases to disconnect the mains power and
remove batteries, then reconnect power after 10 seconds.

If a problem persists our technical staff would be pleased to offer any
assistance on operating the radio. Our technical helpline number is
020 8758 0338.

2,3

2,4