Roberts Radio RecordR User Manual

Page 15

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)

Manual tuning - FM

1. Fully extend the telescopic aerial. The aerial should be fully extended

and positioned vertically for optimum reception.

2. Press

the

On / Off button to switch on your radio.

3. Press and release the Band button until the FM band is selected.

4. Press and release the Select button until the display shows 'Auto

Scan: Off'.

5. Repeatedly press and release the Tuning Up or Down buttons to

tune to a station. The frequency will change in steps of 50kHz.

If the radio is tuned to a station of suffi cient signal strength with RDS
information present, then the display may change to show the station
name.

6. When the waveband end is reached the radio will recommence tuning

from the opposite waveband end.

7. Adjust

the

Volume and Tone controls to the required setting.

8. To switch off your radio press the On / Off button.

Note: If you fi nd that FM reception is poor, try repositioning the Telescopic
aerial. Fully extend and position vertically for optimum reception.If you
fi nd that an FM broadcast has a lot of background hiss, this may often
be reduced by setting the radio into Mono reception mode for the current
FM station. Please refer to the section "Stereo / Mono setting - FM" on
page 16 for further details.