Roberts Radio RecordR - Manual (Page 41)

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
40
Clock display
1. When your radio is in standby mode the time and date will be displayed.
The time is always shown using a 24 hour clock format.
Display backlight dimmer
The brightness of the display can be adjusted when the radio is in use and
when it is in standby. If you use the unit in a bedroom, you may prefer a
lower brightness level than the standard setting. There are three brightness
levels and an almost off 'night time' setting.
1. When the radio is in standby press and release the Info button to
adjust the brightness level.
2. To adjust the display brightness when the radio is in use, press and
hold the Info button.
3. Press the Tuning Up or Down buttons until 'Backlight' appears on
the display. Press and release the Select button.
4. Press the Tuning Up button to increase the brightness and the Tuning
Down button to the decrease brightness.
5. Press and release the Select button to confi rm the setting.
Note: When using the radio powered by the batteries, the display backlight
will be switched on for approximately 10 seconds when any button is pressed.
1,2
3,4 3,4
3,5