RCA VR730HF - Manual (Page 23)

21
Using the Remote Control
Controlling an Auxiliary Component
The remote that came packed with your VCR is also capable of controlling one compatible RCA auxiliary
component, such as an AM/FM radio, CD player, tape players, phonograph, satellite receiver, or DVD. The
remote must be programmed for the specific component it is to control. To program the remote, use the code
that corresponds to your component.
Program the Remote for an Auxiliary Component
1 . Turn on the component.
2 . Point the VCR remote at the component.
3 . Hold the AUX button and press three number buttons to enter the code for your
component.
4 . Release the buttons.
5. Press PWR on the remote. If the component turns off, setup is complete.
Operate the Auxiliary Component
After you have set up your remote to control your component, test the buttons
to see which ones operate the component.
1 . Point the remote at the component and press AUX .
2 . If the component does not turn on in step 1 , press AUX and then PWR.
3. Refer to the ÒRemote ControlÓ section.
*The remote may not be able to control every RCA model of auxiliary type listed.
Type of Auxiliary Equipment and Code
Cassette Cassette
RCA* AM/FM AUX Phono Tape 1 CD DSS Tape 2 DVD
003 004 005 006 007 008 009 010