Renesas User System Interface Cable HS36049ECH61H - Manual (Page 32)

18
Section 5 Notice
1. Make sure that pin 1 on the user system IC socket is correctly aligned with pin 1 on the cable
head before inserting the cable head into the user system IC socket.
2. The dimensions of the recommended mount pad for the user system IC socket are different
from those of the MCU.
3. This user system interface cable is specifically designed for the HS3664EPI61H or
HS3664EPI62H emulator. Do not use this cable with any other emulator station.
4. To prevent breaking of wires in the cable body, do not place heavy or sharp metal objects on
the user system interface cable.
5. While the emulator station is connected to the user system with the user system interface cable,
force must not be applied to the cable head. Place the emulator station, user system interface
cable, and user system as shown in the example in figure 11.
User system
Cable
Emulator station
Connecting User System Interface Cable to Emulator Station (without SCI3_3 for H8/36049 Group)
Connecting User System Interface Cable to Expansion I/O Board (with SCI3_3 for H8/36049 Group)
Place components so that the cable body and cable head are
parallel to the user system.
Cable head is parallel
to emulator station
Cable head is parallel
to user system
Emulator station
User system
Cable
Cable head is parallel
to emulator station
Cable head is parallel
to user system
Expansion I/O board
Place components so that the expansion I/O board, cable body,
and cable head are parallel to the user system.
Figure 11 User System Interface Cable Location Example