Renesas User System Interface Cable HS36049ECH61H - Manual (Page 19)

5
2.2 Connecting User System Interface Cable to Expansion I/O Board
(with Channel 3 of Serial Communication Interface for H8/36049
Group)
WARNING
Always switch OFF the user system and the emulator
product before the USER SYSTEM INTERFACE CABLE
is connected to or removed from any part. Before
connecting, make sure that pin 1 on both sides are correctly
aligned. Failure to do so will result in a FIRE HAZARD and
will damage the user system, the emulator product, and the
expansion I/O board or will result in PERSONAL INJURY.
The USER PROGRAM will be LOST.
To connect the cable body to the emulator station, follow the instructions below.
1. Make sure the user system and emulator station are turned off.
CAUTION
When connecting or removing the user system interface
cable, apply force only in the direction suitable for
connection or removal, while making sure not to bend or
twist the cable or connectors. Otherwise, the connectors
will be damaged.
2. After making sure the direction of the cable body connector is correct, firmly insert the cable
body connector into the expansion I/O board socket (written as USER INTERFACE CABLE),
and fasten the expansion I/O board with two CTS screws (M3
x 6 mm). (figure 3)