RCA RCU410MSL - Manual (Page 9)

16 15
Trouble Shooting
Help Line
Problem
Indicator light not blinking
when you press any button
The remote does not
operate your device
Not performing commands
properly
Problems programming a
TV/VCR Combo Unit
VCR not recording
Channel up and down do not
function on an RCA TV
Problems changing channels
No response after pressing
a button
Sleep feature does not work
IR LEARN cannot be made
successfully
Solution
A) Replace the batteries with
2 new AAA Alkaline
batteries.
B) Check that batteries are
properly installed.
A) Try all the codes listed for
your brand.
B) Try the Code Search
method (page 13).
Start Code Search over again to
locate the proper code.
Try the VCR code for your
brand. Some combo units,
however, may require both a
TV and a VCR code for full
operation.
As a safety feature on your
remote, you must press the
REC button twice.
Due to some designs, the
original remote will only
perform these functions.
If your original remote required
ENTER after a channel, press
ENTER after you select a
channel.
A) Make sure you have new
batteries, and you are
aiming your remote at
your devices.
B) Check that batteries are
properly installed (See
page 3).
Remote must remain aimed at
television after sleep is set in
order for it to work.
A) The batteries in the remote
unit and / or the other
remote unit is weak.
B) The distance between the
t wo remote control units is
too long or too short.
C) Memory capacity is full.
D) The signal coding is not
compatible with this remote
and the other remote.
Note: Reprogramming may be required after batteries are removed.
If you need additional set-up help
please call the Helpline at:
1-800-420-7229
Sleep Feature
This feature will turn off your TV at the time you choose
from 1 to 99 minutes.
To Program Sleep Feature:
1. Press and hold the SLEEP
button. INDICATOR LIGHT
will stay lit. Release the SLEEP
button.
2. Enter time in minutes using the
numerical key pad. Indicator
light should go off.
(Minutes 1 thru 9: press
0
before the actual number
Maximum: 99 minutes)
3. Leave remote aimed at
television. (Sleep Feature will
not work unless remote is left
aimed at television.)
INDICATOR
LIGHT
To Turn Off The Sleep Timer:
Sleep timer program will be
cancelled and reset to zero by
either of the following:
1. Press and hold SLEEP
button until INDICATOR
LIGHT blinks or press
ON•OFF button, turning
TV OFF.
(BLINK)
RCU410MSL_IB 10/4/01 1:58 PM Page 16